Olymstore SRP8 Nano 8CH PPM Receiver D8 protocol 300M Range for DHT DFT DJT XJT X9D plus X9E Transmitter Frysky Taranis RC Drone
- 8-channel receiver module with ppm signal output. Precise fit, fairly easy to install, compact and 300m of control range. Stable performance, high reliability. Compatible transmitter dht, dft, djt, xjt, x9d plus, x9e. 2g with the servo plug, 14 without, add minimum weight to your micro or mini quad.
Usmile 32bit Brushed F3 EVO Flight Control Board with Built-in PPM 6CH FLYSKY Compatible Receiver for Mini Micro Nano quad fpv racing
- Built-in flysky 6ch ppm receiver, compatible with fs i6,echine i6,th9x,devo 7e with a7105 module. Features stm32f303 72mhz + mpu6500, advanced hardware guarantee more stable flight. Based on f3 flight controller with flysky receiver built to it to save your time and make your build clean, specially designed and built for quads around 100mm and sub 100mm class. Pre-flashed with cleanflight 1130, support betaflight default receiver channel map aetr1234, default arm channel aux1(channel 5). Low voltage detection, buzzer, led_strip function,support ws2812 light.
HOBBYMATE Brushed F3 Mini Flight Controller for Micro FPV Quadcopter Support 1-2S lipo, Compatible DSM2/DSMX S.Bus PPM Radio Receiver
- 2 ultra micron in size with a 20mm x 25mm size£¬ levitation worthy at 3 g in all up weight. 5 support for ppm, sbus, dsm/dsm2/dsmx receiver input signal, support of the world almost all hollow cup motor, including 615 720 820 8520 1020 coreless motor. 3 (4) esc’s built in, quad ready, max 6a each esc. 4 5v 400-500ma built in switch bec. 1 integrated pdb for the ultimate in simplicity, f3 chip with cleanflight & betaflight software.
Crazepony DIY Frsky 8CH Receiver RX PPM Output for X9D Plus XJT DJT DFT DHT
- 5vinput currentandlt=50mappm outputfeasture- compatible with frsky x9d remote controller (d8 mode), xjt(d8 mode), dft,djt,dht- fail-safe protection , only support third channel protection. Package included1 x diy frsky 8ch receiverpackage including1 diy frsky 8ch receiver. Descriptionitem name diy frsky 8ch receiverchannel 8weight 5ginput voltage4-6.
Usmile 32bit NAZE32 BRUSH Flight Control Support Hexacopter Maximum 6 motors PPM SBUS DSM2 DSMX receiver 1s 2s battery buzzer Voltage monitor for Mini Micro Nano quad indoor fpv racing
- Support 1s (default) and 2s (84v) lipo battery,with 2s, you could get even more fierce racing experience than 1s. Based on naze32 flight controller , specially designed and built for brush quads around 100mm and sub 100mm class. Support quadcopter and hexacopter, giving you more choices. Dimensions22mm 325mm, thickness 12mm. Support for ppm, sbus, dsm2 dsmx receiver, support battery voltage monitor and buzzer function.
Usmile Tiny 8CH PPM Receiver Compatible with FRSKY ACCST X9D(Plus)DJT/DFT/DHT For QX95 QX90 Micro Indoor FPV racing (PPM)
- Range approx 500m. Compatible with frsky accst, x9d(plus)djt/dft/dht. Work mode d8 mode. Small and light weight, weight1g, dimensions 17x12x5mm. 8ch, operating voltage5v.
New DasMikro Flysky 8CH 2.4Ghz Micro PPM Receiver By KTOY
- Bindthere is no bind pin designed, the receiver has an “autobind” procedure just like with small quad-copters. If it can’t bind with a transmitter then is retrieves previously bind transmitter identifier and works with it. If receiver find a transmitter (must be also in bind mode) then it records transmitter identifier and works with it. Dasmikro flysky 8ch 2. This way, you save an extra pin and just need to bind only once. Receiver sensitivity -100dbmpower 3. 4g 8ch micro ppm receiverchannels 8chfrequency band 2. 25mm 3p socket. 4 ghz afhdsmodulation gfsksensitivity 1024rf. Package included1 x flysky 8ch micro ppm receiver1 x 1. Failsafepush the failsafe button the receiver will record 8 channels’ position as failsafe output. 4ghz transmitter afhds protocol. After bind procedure, if reception is ok then led if on, if no reception at all led if off, if reception if bad led is blinking randomly. 4ghz 8-channel receiver for flysky transmitter, compatible with flysky gt2b, gt3b,gt3c, i6 i10 t6 ct6b th9x 2. When switch on, receiver tries to bind with transmitter for about 3s (led is blinking). 25mm 3p plug with cable2 x 1. 7~12v dcantenna length about 170mmsize (whxd) 27 x 17 x 18mmweight 5gcolour bluece & fcc certifiedfeaturesstandard 2. 4ghz micro ppm receiverdescriptionitem name flysky 2. Compact size design with auto-bind and failsafe function.
Lemon Rx PPM Receiver with Diversity Antenna LM0039
- It can be used on triditional pwm receivers or fpv racing flight controller. Lemon rx. The tiny buzzer is drived by on board mcu it can output louder sound than 5v active buzzers. Working voltage range 45-52v dc power 1w max sound output 90db max.
Crazepony SRP8 Mini 8CH PPM Receiver D8 protocol 1G Weight Conpatible for FrSky DHT DFT DJT XJT X9D Plus X9E Transmitter
- Specificationitem name srp8 8ch ppm receiverprotocol d8 protocolchannels 8output ppmnumber of channels 8range 300mweight 1gdimensions20154. 8mm (lwh)working voltage5vworking current 100macompatible transmitter dht, dft, djt, xjt, x9d plus, x9epackage including1 srp8 8ch ppm receiver d8 protocol conpatible for frsky dht dft djt xjt x9d plus x9e transmitter.
LHI 2.4G FS-iA6B Flysky Six-channel PPM Receiver Compatible iBus Port Output For Flysky i6 i4 i10 Transmitter
- It is reliable, operates with 24 ghz afhds2a signal, safe and steady and does not interfere with. 24g mode is an improved version of the second generation digital automatic fm system with six channels to provide better signal. Ultra-light weight, it is only 149g weight, reduce your aircraft load, let it fly higher and farther, loaded more things. Applicable to aircraft / glider / helicopter, with i-bus interface and data acquisition interface. Better compatibility, it can be compatible with fs-i4, fs-i6, fs-i10, fs-gt2e, fs-gt2g variety of transmitters, reduce your trouble.
Crazepony Matek 90dB 5V Loud Buzzer Lost Model Beeper Built-in MCU for CC3D Naze32 F3 F4 Flight Controller and PPM Receiver
- The tiny buzzer is drived by on board mcu it can output louder sound than 5v active buzzers. It can be used on triditional pwm receivers or fpv racing flight controller. Working voltage range 45-52v dc power 1w max sound output 90db max. Size 18x13x8mmweight 2g.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
